Every month or so, wipe the faucet with wax to seal the small holes on the surface of the electroplating layer, avoid moisture or corrosive gases running in; use a little toothpaste on the softer cloth to clean the faucet surface, and then rinse it with clean water. But do not use alkaline detergent or steel ball to wipe, to avoid damage to the plating surface; in the process of using single-handle faucet, do not open and close too fast; in addition, do not close the double-handle faucet too fast, otherwise it will make the water stop off, causing water flow not stop, can not close the switch; foaming device located at the tap outlet, often because of water quality problems, water quantity occurs.
Small or unstable situation, this may be because the former is blocked by debris, can screw down the former to remove debris with clean water or needle; periodically check the hose up and down water, once cracking phenomenon is found, it should be replaced immediately, so as to ensure that the service life of the tap is not affected. In fact, after a period of time, we should check and clean the faucet to avoid inconvenience caused by damage.